Differences

This shows you the differences between two versions of the page.

--- amp_led_uv-cube_ii [2024/10/10 17:03] – mbates
+++ amp_led_uv-cube_ii [2024/10/10 17:08] (current) – [Safety Concerns] mbates
@@ Line 26: / Line 26: @@
 LED source: 365 nm\\
-^Tray Position ^Power Setting  |
+^  Tray Position  ^  Power Setting  |
-|top | 32 mW/cm<sup>2</sup> |
+|  top  |  32 mW/cm<sup>2</sup>  |
-|middle | 17 mW/cm<sup>2</sup> |
+|  middle  |  17 mW/cm<sup>2</sup>  |
-|bottom | 12 mW/cm<sup>2</sup>  |
+|  bottom  |  12 mW/cm<sup>2</sup>  |
 ----
@@ Line 36: / Line 36: @@
-*    Allow at least half an hour for IPA to evaporate before placing part in Form Cure\\
+*    Allow at least half an hour for IPA to evaporate before placing part in FormCure\\
-*    Allow time for the Form Cure to cool off before removing parts\\
+*    Allow time for the FormCure to cool off before removing parts\\
-*    Do not operate form cure with lid open
+*    Do not operate FormCure with lid open