formcure_uv
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| formcure_uv [2020/10/08 16:58] – [Detailed Specifications] furst | formcure_uv [2020/10/08 17:00] (current) – [Operating Procedures] furst | ||
|---|---|---|---|
| Line 26: | Line 26: | ||
| * Max cure temp: 80 degrees C | * Max cure temp: 80 degrees C | ||
| * Light: 39W total drawn by 13 405 nm LEDs | * Light: 39W total drawn by 13 405 nm LEDs | ||
| - | * | ||
| Line 33: | Line 32: | ||
| ===== Safety Concerns ===== | ===== Safety Concerns ===== | ||
| - | Insert Text Here! | + | * Allow at least half an hour for IPA to evaporate before placing part in Form Cure |
| + | * Allow time for the Form Cure to cool off before removing parts | ||
| + | * Do not operate form cure with lid open | ||
| ---- | ---- | ||
| Line 44: | Line 45: | ||
| - Use the dial on the front of the FormCure to set time and temperature | - Use the dial on the front of the FormCure to set time and temperature | ||
| - Place part within the FormCure-> | - Place part within the FormCure-> | ||
| - | ---- | + | |
| + | ----- | ||
| ===== Reference Documentation ===== | ===== Reference Documentation ===== | ||
| Line 58: | Line 60: | ||
| ===== Training Documentation ===== | ===== Training Documentation ===== | ||
| - | + | [[form2sop|Form 2 Training SOP]] | |
| - | Insert Text Here! | + | |
| ---- | ---- | ||
formcure_uv.1602176306.txt.gz · Last modified: 2020/10/08 16:58 by furst