Differences

This shows you the differences between two versions of the page.

--- machine_tools [2020/01/31 21:13] – magnuson
+++ machine_tools [2020/07/13 19:00] (current) – [Sander] furst
@@ Line 3: / Line 3: @@
 ===== Safety Concerns =====
-===== Approved Materials =====
-=== Bandsaw ===
+===== Sequences of Operation =====
-Ferrous and hard metals (steels, stainless steels, titanium)
-Non-Ferrous metals (aluminum, bronze, brass, copper)
+==== Bandsaw ====
-Wood
-Plastics
+==== Documentation ====
+{{:tools:rikonbandsaw:https_www.rikontools.com_manuals_10-326.pdf|}}\\
+{{:tools:rikonbandsaw:rikon_bandsaw.pdf|}}
-=== Drill Press ===
+=== Approved Materials ===
 Ferrous and hard metals (steels, stainless steels, titanium)
 Non-Ferrous metals (aluminum, bronze, brass, copper)
@@ Line 17: / Line 18: @@
 Plastics
-===== Sequences of Operation =====
+=== Checklist ===
-==== Bandsaw ====
 . Adjust the blade guard to be approximately 1/4" above your material. Twist the rear knob to loosen the guard and move up and down using the upper wheel handle.
@@ Line 49: / Line 48: @@
 . Use the shop vac to clean the saw table, return the table to upright position, lower the blade guard, roll the saw back, and lock the casters.
+----
 ==== Drill Press ====
-==== Grinder ====
+=== Documentation===
+{{:tools:wen_drill_press:coe_student_machine_shop_safety_handout.pdf|}}\\
+{{:tools:precisionsmillingmachine:drill_press_sop.docx|}}
+=== Approved Materials ===
+Ferrous and hard metals (steels, stainless steels, titanium)
+Non-Ferrous metals (aluminum, bronze, brass, copper)
+Wood
+Plastics
+----
+==== Grinder ====
+=== Documentation===
+{{:tools:precisionsmillingmachine:grinder_sop.pdf|}}
+----
 ==== Sander ====
+===Documentation===
+{{:tools:precisionsmillingmachine:sander_sop.docx|}}
+----