Differences

This shows you the differences between two versions of the page.

--- sca_naoh_bath [2020/07/09 18:21] – [Safety Concerns] furst
+++ sca_naoh_bath [2020/10/08 17:08] (current) – [Detailed Specifications] furst
@@ Line 23: / Line 23: @@
 ===== Detailed Specifications =====
+  * Available Temperatures: 50, 60, 70, 85 degrees C
+  * Auto overfill alarm
+  * 46.3 L tank
-Insert Text Here!
 ----
@@ Line 35: / Line 37: @@
 ===== Operating Procedures =====
-Insert Text Here!
+  - Remove completed part on build tray from F270 3D printer
+  - Remove part from build tray, making sure to scrape build tray free of ALL residue
+  - Dawn lab coat, nitrile gloves, and a face shield
+  - Open lid on SCA 1200 HT
+  - Slowly lift large basket, allow time to for excess solution to drip back into SCA 1200HT \\ NOTE: If solution rises above specific level alarm will sound, this is common when lifting or lowering basket and means you're moving too fast!
+  - Rotate basket 90 degrees to rest on lip while adding part
+  - Open basket, place part inside (if part is small, consider using smaller stainless steel cage located near by
+  - Close basket and SLOWLY lower back into solution (alarm will sound if lowered too quickly.
+  - Select desired temperature and use the "Set" button and arrows to select desired time
+  - Press power button to begin wash
+  - Follow steps 3-6 to remove part, followed by steps 8 to replace basket
+  - Part should be allowed to drip, before being rinsed in sink with plenty of warm water
 ----
@@ Line 43: / Line 55: @@
 {{:tools:scanaohbath:sca_1200ht_user_manual.pdf|}}
+{{:tools:scanaohbath:msds-010-waterworks-concentrate-sds-400625-b-en-aghs-p400sc-wateworks-cleaning-solution.pdf|}}
 ----
 ===== Training Documentation =====
-Insert Text Here!
+[[f270_sop|FDM Training SOP]]
 ----