Differences

This shows you the differences between two versions of the page.

--- trotec_speedy [2020/08/31 18:48] – furst
+++ trotec_speedy [2020/10/23 16:45] (current) – [Training Documentation] furst
@@ Line 24: / Line 24: @@
 ----
 ===== Training Documentation =====
+{{ :tools:rayjet300:laser_cutter_slide_deck.pptx |Laser Cutter Training Slide Deck}}
+[[https://forms.gle/WEvL3zkSGAHj7je36|Laser Cutter Slide Deck Quiz (responses collected)]]
 [[Laser Cutter Training SOP]]
@@ Line 37: / Line 40: @@
 ===== Safety Concerns =====
-Looking directly into the laser can cause retinal damage. Confirm that the fume collection system is running whenever the laser is cutting or engraving. See list of approved materials for laser cutting, some require nitrogen gas if flammable, or could release chlorine gas if cut. NO NOT CUT NON APPROVED MATERIALS INCLUDING METALS. Laser lenses must be cleaned within ONE WEEK of time of use. If lenses has not been cleaned, clean before use to avoid damaging lenses.
+  * Looking directly into the laser can cause retinal damage.
+  * Confirm that the fume collection system is running whenever the laser is cutting or engraving.
+  * See list of approved materials for laser cutting, some require nitrogen gas if flammable, or could release chlorine gas if cut.
+  * NO NOT CUT NON APPROVED MATERIALS INCLUDING METALS.
+  * Laser lenses must be cleaned within ONE WEEK of time of use. If lenses has not been cleaned, clean before use to avoid damaging lenses.
 ----