Differences

This shows you the differences between two versions of the page.

--- ultimaker_3_sop [2020/08/27 16:29] – furst
+++ ultimaker_3_sop [2021/04/27 17:40] (current) – furst
@@ Line 10: / Line 10: @@
 !
-Name
+Name (Last, First)
 !
 Group or Company
 !
-Signature
+Signature (First, Last)
 |-
 |1
@@ Line 46: / Line 46: @@
 |
 |}
+-----
 ====Overview:====
   * This training provides an introduction to using and operating the FDM 3D printers including:
@@ Line 72: / Line 72: @@
     -Load your STL file into the print software on the computer adjacent to the printer (Cura for Ultimaker, GrabCad Print for F270).
     - Set Print Parameters:
-      - Position the part on the build tray in a way that is conducive to 3D printing (flat side down)
+      - Position the part on the build tray in a way that is conducive to 3D printing (flat side down, minimize overhangs etc..)
       - Select appropriate layer or slice height (the more slices the higher the print resolution but the longer it takes to print)
     - For Ultimaker:
@@ Line 151: / Line 151: @@
   * Filament should be dried before use if printer has been idle for several weeks
   * Bed leveling should be completed every time print cores are swapped
-  * Print cores should be swapped after clog or to change print line width. Used print heads should be kept for spare parts
+  * Print cores should be swapped  or purged after clog or to change print line width. Used print heads should be kept for spare parts
 -----
+[[ruler]]