====== Trotec Speedy 100 ======


^             Trotec Speedy 100                                              ^
|         {{ :tools:trotecspeedy:trotec_speedy.jpg?nolink&200 |}}            |
| **Tool Type:**                  "Laser Cutter"                                |
| **Location:**                   "Microfluidics lab"                                |


|  **Supervisor**        |  **Tool Lead**  |     
|  David Bothman         |  Jeran Bruce & Vedad Bassari  |
|  (805) 893-4125        |  (424) 610-6312 & (818) 942-5523  |
|  bothman@cnsi.ucsb.edu  |  jrbruce@ucsb.edu & vedad@ucsb.edu  |

| **Description:**                "Bright Light Cutter"                           |
| **Manufacturer:**               "Trotec"                           |

----

===== About =====

One of two laser cutters, the Trotec is located in the Innovations Workshop above its fume extractor. Both laser cutters utilize CorelDraw as a 2D sketch manager which is then imported into Trotec's specific cutting software. CorelDraw can be used to create the 2D sketch, however importing a DXF file or PDF into CorelDraw from Solidworks or other CAD packages is preferred due the CAD packages integrated features and functions.

----
===== Training Documentation =====
{{ :tools:rayjet300:laser_cutter_slide_deck.pptx |Laser Cutter Training Slide Deck}}

[[https://forms.gle/WEvL3zkSGAHj7je36|Laser Cutter Slide Deck Quiz (responses collected)]]

[[Laser Cutter Training SOP]]
----

===== Detailed Specifications =====
Work Area: 910 x 305 mm\\
Max Workpiece Height: 125 mm \\
Laser Power: 10-120 Watts

----

===== Safety Concerns =====

  * Looking directly into the laser can cause retinal damage. 
  * Confirm that the fume collection system is running whenever the laser is cutting or engraving. 
  * See list of approved materials for laser cutting, some require nitrogen gas if flammable, or could release chlorine gas if cut. 
  * NO NOT CUT NON APPROVED MATERIALS INCLUDING METALS. 
  * Laser lenses must be cleaned within ONE WEEK of time of use. If lenses has not been cleaned, clean before use to avoid damaging lenses.

----

===== Reference Documentation =====

{{:tools:trotecspeedy:marking_tape_notes.pdf|Marking Tape/Paint}}

{{:tools:trotecspeedy:atmos_compact_operationmanual_v1_13_gb.pdf|Operation Manual}}

{{:tools:trotecspeedy:servicemanual_8003v14.pdf|Service Manual}}

{{:tools:trotecspeedy:synrad_laserprocessingguide_plastics.pdf|Plastic Processing Guide}}

{{:tools:trotecspeedy:trotec_job_control_software_manual.pdf|Job Control Software Manual}}


[[Laser cutting data]]