Differences

This shows you the differences between two versions of the page.

--- amp_led_uv-cube_ii [2024/10/10 17:02] – [Detailed Specifications] mbates
+++ amp_led_uv-cube_ii [2024/10/10 17:08] (current) – [Safety Concerns] mbates
@@ Line 1: / Line 1: @@
 ====== UV Curing Oven ======
-^                  AMP LED UV-Cube                  ^
+^                  APM LED UV-Cube                  ^
 |          {{:uvcuringoven.png?400|}}           |
 | **Tool Type:**                  UV Curing Oven                           |
 | **Location:**                   Elings 2436                           |
-| **Manufacturer:**               AMP                           |
+| **Manufacturer:**               APM                           |
@@ Line 18: / Line 18: @@
 The UV curing oven is located in Elings Hall 2436.
-Some Carbon Resins used in the Form 2 3D printer can benefit from post process curing. Each resin has a specific hardening curve which can be found within the reference material which will indicate the ideal time and temperature to be set on the AMP UV curing oven.
+Some Carbon Resins used in the Form 2 3D printer can benefit from post process curing. Each resin has a specific hardening curve which can be found within the reference material which will indicate the ideal time and temperature to be set on the APM UV curing oven.
 ----
@@ Line 26: / Line 26: @@
 LED source: 365 nm\\
-^Tray Position ^Power Setting  |
+^  Tray Position  ^  Power Setting  |
-|top | 32 mW/cm<sup>2</sup> |
+|  top  |  32 mW/cm<sup>2</sup>  |
-|middle | 17 mW/cm<sup>2</sup> |
+|  middle  |  17 mW/cm<sup>2</sup>  |
-|bottom | 12 mW/cm<sup>2</sup>  |
+|  bottom  |  12 mW/cm<sup>2</sup>  |
 ----
@@ Line 35: / Line 36: @@
-*    Allow at least half an hour for IPA to evaporate before placing part in Form Cure\\
+*    Allow at least half an hour for IPA to evaporate before placing part in FormCure\\
-*    Allow time for the Form Cure to cool off before removing parts\\
+*    Allow time for the FormCure to cool off before removing parts\\
-*    Do not operate form cure with lid open
+*    Do not operate FormCure with lid open
@@ Line 53: / Line 54: @@
 ===== Reference Documentation =====
-{{ :amp_led_uv-cube_ii.pdf | AMP LED UV-Cube II User Manual}}
+{{ :amp_led_uv-cube_ii.pdf | APM LED UV-Cube II User Manual}}