carbide3d_nomad
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| carbide3d_nomad [2020/07/23 17:05] – [Detailed Specifications] furst | carbide3d_nomad [2020/09/11 17:33] (current) – [Detailed Specifications] furst | ||
|---|---|---|---|
| Line 23: | Line 23: | ||
| ---- | ---- | ||
| + | ===== Training Documentation ===== | ||
| + | [[Carbide 3D Nomad 883 Training SOP]] | ||
| + | ---- | ||
| ===== Detailed Specifications ===== | ===== Detailed Specifications ===== | ||
| * Cutting Volume: 8" x 8" x 3" (X,Y,Z) | * Cutting Volume: 8" x 8" x 3" (X,Y,Z) | ||
| * Spindle Speed: 2, | * Spindle Speed: 2, | ||
| * Software: Carbide Motion, Mesh Cam | * Software: Carbide Motion, Mesh Cam | ||
| + | * Spindle Taper: ER11 | ||
| + | |||
| ---- | ---- | ||
| ===== Safety Concerns ===== | ===== Safety Concerns ===== | ||
| - | Insert Text Here! | + | * Safety Glasses must be worn when machine is running |
| + | * The acrylic shield must be in place and lowered before starting a job | ||
| + | * The spindle must be completely stopped before adjusting or removing work piece | ||
| + | * After milling is completed, the work piece will have developed sharp burrs which must be removed with a hand file or sandpaper | ||
| ---- | ---- | ||
| - | ===== Operating Procedures ===== | ||
| - | |||
| - | Insert Text Here! | ||
| - | |||
| - | ---- | ||
| ===== Reference Documentation ===== | ===== Reference Documentation ===== | ||
| Line 49: | Line 52: | ||
| ---- | ---- | ||
| - | ===== Training Documentation ===== | ||
| - | Insert Text Here! | ||
| - | ---- | ||
carbide3d_nomad.1595523940.txt.gz · Last modified: 2020/07/23 17:05 by furst