NSF BioPACIFIC MIP Wiki

A National User Facility Dedicated to Biomaterials

User Tools

Site Tools

Trace:
carbide_3d_nomad_883_training_sop

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
carbide_3d_nomad_883_training_sop [2020/09/08 20:12] – furstcarbide_3d_nomad_883_training_sop [2020/09/13 21:47] (current) – furst
Line 115: Line 115:
   - With the tool installed, make sure the bed is empty and the cover is closed before turning on the machine   - With the tool installed, make sure the bed is empty and the cover is closed before turning on the machine
   - Launch Carbide Motion on the Carbide computer   - Launch Carbide Motion on the Carbide computer
-  - Under "Jog" select "Home Machine" and allow machine to home+  - Under "Jog" select "Home Machine" and allow machine to home itself
   - Select "measure tool" and the machine will use the automatic tool length measuring tool to zero out the tool   - Select "measure tool" and the machine will use the automatic tool length measuring tool to zero out the tool
-  - Next while still under "Jog" position the tool on the work piece zero and zero out the machine by pressing "zero"+  - Next while still under "Jog" position the machine can set part zero in three ways 
 +    - The less accurate way is to position the tool at part zero established in HSM Works by jogging the machine to the part zero location and pressing zero 
 +    - An edge finder can be used at the minimum RPM to find the part X and Y zero. The cutting tool can then be replaced in the spindle and re-zeroed using the automatic tool length touch off. Z zero can be established by sliding a paper of known thickness or a thin metal shim along the top of the part and slowly jogging the spindle down until slight resistance is felt on the shim from the tool tip. X and Y axles must then be adjusted by the radius of the edge finder, and Z Zero must be offset by the shim thickness 
 +    - The fastest way to establish part zero is by using the paper or shim on all three axis and offsetting X and Y by the radius of the tool plus shim thickness, and the Z axis by shim thickness.  
  
 **Starting Job:** **Starting Job:**
Line 153: Line 157:
     - Simulate the toolpaths to verify that the tool will not crash and is cutting in the desired location     - Simulate the toolpaths to verify that the tool will not crash and is cutting in the desired location
   - Using the 17 and 11 mm wrenches loosen the collet nut to change out the tool or collet itself if switching shank diameter   - Using the 17 and 11 mm wrenches loosen the collet nut to change out the tool or collet itself if switching shank diameter
-  - Home the machine and zero the tool using Carbide Motion under the "jog" heading+  - Home the machine and zero the tool using Carbide Motion under the "jog" heading using paper or a shim. DO NOT FORGET TO ADD OFFSET OF TOOL RADIUS AND SHIM THCINESS
   - Upload the G-Code into Carbide Motion under "load"   - Upload the G-Code into Carbide Motion under "load"
   - Start program   - Start program
carbide_3d_nomad_883_training_sop.1599595934.txt.gz · Last modified: 2020/09/08 20:12 by furst