einscantrainginsop
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
einscantrainginsop [2020/09/04 17:59] – furst | einscantrainginsop [2020/09/04 18:13] (current) – furst | ||
---|---|---|---|
Line 232: | Line 232: | ||
====Safe Operation Procedures Review==== | ====Safe Operation Procedures Review==== | ||
- | - Check resin cartridge | + | - Create a new project |
- | - If resin is not desired | + | - Select |
- | - Launch Preform on Ultimaker computer | + | - Adjust brightness slider to properly expose image |
- | - Import desired STL | + | - Select desired |
- | - Select | + | - Start Scan |
- | - Select print (orange button) from top left menu | + | - After scan completion using shift + left click to remove extraneous data |
- | - Select desired printer | + | - Correct any misalignment using the align and shift + left click to select coincident points |
- | - Press button on Formlabs printer | + | ====Post Processing |
- | + | - Select mesh to convert to mesh body | |
- | ====Post Processing==== | + | - Select watertight |
- | - Excess resin should be removed from the build tray and part with IPA over a waste container. | + | - Select desired simplification ratio (to reduce processor stress) |
- | - Place build tray and part in the Form Wash for 20 to 30 minuets (part can be placed individually within basket if necessary | + | |
- | - Allow 30 minuets for IPA to evaporate before placing part in Form Cure | + | |
- | - Set Form Cure time and temperature based on resin type, place part within form cure, wait for time to elapse | + | |
====Maintenance==== | ====Maintenance==== | ||
- | * Switching resin types | + | * Calibration should take place once a week or before a scan for optimal accuracy |
- | * Close breather valve on resin cartridge | + | * Scanner |
- | * Resin cartridge by pulling straight up on the handle behind the form labs printers | + | * Computer should be restarted periodically |
- | * Cap the cartridge valve using the included orange tap and cap | + | |
- | * Remove the wiper by pulling straight out towards the front of the fume hood. | + | |
- | * Pull the resin tray out of the printer by pulling firmly straight out toward you | + | |
- | * Lift the wiper and resin tray out simultaneously, | + | |
- | * Cover resin tray with black plastic cover and label | + | |
- | * Replace resin tray with clean or desired resin tank. Push tank and wiper firmly back toward the Form 2 until it clicks into place | + | |
- | * Replace resin cartridge and open valve | + | |
einscantrainginsop.1599242399.txt.gz · Last modified: 2020/09/04 17:59 by furst