Differences

This shows you the differences between two versions of the page.

--- f270_sop [2020/08/27 16:39] – furst
+++ f270_sop [2020/08/27 16:45] (current) – [Maintenance Schedule (see user maintenance page 80):] furst
@@ Line 123: / Line 123: @@
 ABS: .12/gram
 -----
-=====Ultimaker 3 Quick Review=====
+=====F270 Quick Review=====
 Tool Lead: Andrew Furst \\
 Contact: Andrewfurst@ucsb.edu
 ====Safety Concerns====
   * Both print heads and bed are heated during operation. Do not attempt to clean, remove, or adjust without allowing for adequate cool down time.
-  * Keep hands clear of printer during operation. Pause print before clearing or adjusting print.
+  * Keep hands clear of printer during operation. Pause print before clearing or adjusting part.
  ====Safe Operating Procedures Review====
@@ Line 142: / Line 142: @@
 ====Post Processing====
-  * If support was constructed from ABS carefully break away with pliers
+  * If support was constructed from dissoluble filament clean using the F270 Support Removal Apparatus which is filled with heated caustic chemicals. GLOVES, LAB COAT, AND FACE SHIELD MUST BE WORN
-  * If support was constructed from PVA soak part in warm water for several hours to dissolve support structure
+  * Build tray should be scraped clean and free of any support or build material then placed in the USED F270 tray drawer if printable space is left. Any material protruding from the build tray will damage print heads during the next print.
-====Maintenance====
+====Maintenance Schedule (see user maintenance page 80):====
-  * Bed should be cleaned with IPA between prints
+  * Clean oven chamber weekly
-  * Print heads and silicone head protector should be cleaned as needed
+  * Clean platen weekly
-  * Filament should be dried before use if printer has been idle for several weeks
+  * Inspect, wipe, and clean tip wipe assemblies monthly
-  * Bed leveling should be completed every time print cores are swapped
+  * Clean exterior of printer as needed
-  * Print cores should be swapped  or purged after clog or to change print line width. Used print heads should be kept for spare parts
+  * Clean touchscreen as needed
 -----