Differences

This shows you the differences between two versions of the page.

--- formcure_uv [2020/04/03 22:29] – created martinez
+++ formcure_uv [2020/10/08 17:00] (current) – [Operating Procedures] furst
@@ Line 3: / Line 3: @@
 ^                   FormCure UV Curing Station                          ^
 |            {{ :tools:formcureuv:formcureuv.png?nolink&200 |}}         |
-| **Tool Type:**                  "TEXT HERE"                           |
+| **Tool Type:**                  "UV Curing Station"                           |
-| **Location:**                   "TEXT HERE"                           |
+| **Location:**                   "Innovations Worship"                           |
@@ Line 12: / Line 12: @@
 |  bothman@cnsi.ucsb.edu  |  "WW Email"  |
-| **Description:**                "TEXT HERE"                           |
+| **Description:**                "FormLabs Curing Station"                           |
-| **Manufacturer:**               "TEXT HERE"                           |
+| **Manufacturer:**               "FormLabs"                           |
 ----
@@ Line 19: / Line 19: @@
 ===== About =====
-Insert Text Here!
+Some FormLabs Resins used in the Form 2 3D printer can benefit from post process curing. Each resin has a specific hardening curve which can be found within the reference material which will indicate the ideal time and temperature to be set on the FormCure.
 ----
 ===== Detailed Specifications =====
+  * Max cure temp: 80 degrees C
+  * Light: 39W total drawn by 13 405 nm LEDs
-Insert Text Here!
 ----
@@ Line 31: / Line 32: @@
 ===== Safety Concerns =====
-Insert Text Here!
+  * Allow at least half an hour for IPA to evaporate before placing part in Form Cure
+  * Allow time for the Form Cure to cool off before removing parts
+  * Do not operate form cure with lid open
 ----
@@ Line 37: / Line 40: @@
 ===== Operating Procedures =====
-Insert Text Here!
+  - Any part to be cured needs to be washed in the FormWash with IPA BEFORE being placed in the form cure. Supports can be removed before or after curing process.
+  - Wait 30 minutes after washing to allow all remaining IPA to evaporate
+  - Check the reference material for selected resin to determine ideal time and temperature for curing
+  - Use the dial on the front of the FormCure to set time and temperature
+  - Place part within the FormCure-> press start.
-----
+-----
 ===== Reference Documentation =====
+[[https://support.formlabs.com/s/article/Using-Form-Cure?language=en_US]]
-Insert Text Here!
+[[https://support.formlabs.com/s/article/Form-Cure-Time-and-Temperature-Settings?language=en_US]]
-===== Training Documentation =====
+[[https://support.formlabs.com/s/article/Form-Cure-Time-and-Temperature-Settings?language=en_US]]
-Insert Text Here!
+===== Training Documentation =====
+[[form2sop|Form 2 Training SOP]]
 ----