Differences

This shows you the differences between two versions of the page.

--- rayjet_300 [2020/07/15 17:31] – [About] furst
+++ rayjet_300 [2020/08/31 18:46] (current) – [Reference Documentation] furst
@@ Line 15: / Line 15: @@
 | **Manufacturer:**               "Trotec"                           |
-----
+-----
 ===== About =====
@@ Line 22: / Line 22: @@
 ----
+===== Training Documentation =====
+[[laser_cutter_training_sop|Laser Cutter Training SOP]]
+----
 ===== Detailed Specifications =====
@@ Line 33: / Line 36: @@
 ===== Safety Concerns =====
-Insert Text Here!
+Looking directly into the laser can cause retinal damage. Confirm that the fume collection system is running whenever the laser is cutting or engraving. See list of approved materials for laser cutting, some require nitrogen gas if flammable, or could release chlorine gas if cut. NO NOT CUT NON APPROVED MATERIALS INCLUDING METALS. Laser lenses must be cleaned within ONE WEEK of time of use. If lenses has not been cleaned, clean before use to avoid damaging lenses.
 ----
-===== Operating Procedures =====
+===== Reference Documentation =====
+[[Laser cutting data]]
-Insert Text Here!
+{{:tools:rayjet300:rayjet-300_8024_operationmanual_en.pdf|Operations Manual}}
-----
+{{:tools:rayjet300:rayjet_8015_software-manual_en.pdf|Software Manual}}
-===== Reference Documentation =====
+{{:tools:rayjet300:exhaust_system_information.pdf|Exhaust System Info}}
-{{:tools:rayjet300:rayjet-300_8024_operationmanual_en.pdf|}}
+{{:tools:rayjet300:rayjet_laser_cutter_notes.pdf|Laser Cutter Notes}}
-{{:tools:rayjet300:rayjet_8015_software-manual_en.pdf|}}
-{{:tools:rayjet300:exhaust_system_information.pdf|}}
-===== Training Documentation =====
-{{:tools:rayjet300:trotec_laser_training_r0.6.docx|}}
-{{:tools:rayjet300:rayjet_laser_cutter_notes.pdf|}}
-{{:tools:rayjet300:workshop_wizard_project_information_form_-_updated_laser_cutter_sop.pdf|}}
-{{:tools:rayjet300:trotec_and_rayjet_training_sign_in.pdf|}}
-{{:tools:rayjet300:trotec_rayjet_sop.pdf|}}
-----