ultimaker_3_sop
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| ultimaker_3_sop [2020/08/27 16:30] – [Maintenance] furst | ultimaker_3_sop [2021/04/27 17:40] (current) – furst | ||
|---|---|---|---|
| Line 10: | Line 10: | ||
| ! | ! | ||
| - | Name | + | Name (Last, First) |
| ! | ! | ||
| Group or Company | Group or Company | ||
| ! | ! | ||
| - | Signature | + | Signature |
| |- | |- | ||
| |1 | |1 | ||
| Line 46: | Line 46: | ||
| | | | | ||
| |} | |} | ||
| + | ----- | ||
| ====Overview: | ====Overview: | ||
| * This training provides an introduction to using and operating the FDM 3D printers including: | * This training provides an introduction to using and operating the FDM 3D printers including: | ||
| Line 72: | Line 72: | ||
| -Load your STL file into the print software on the computer adjacent to the printer (Cura for Ultimaker, GrabCad Print for F270). | -Load your STL file into the print software on the computer adjacent to the printer (Cura for Ultimaker, GrabCad Print for F270). | ||
| - Set Print Parameters: | - Set Print Parameters: | ||
| - | - Position the part on the build tray in a way that is conducive to 3D printing (flat side down) | + | - Position the part on the build tray in a way that is conducive to 3D printing (flat side down, minimize overhangs etc..) |
| - Select appropriate layer or slice height (the more slices the higher the print resolution but the longer it takes to print) | - Select appropriate layer or slice height (the more slices the higher the print resolution but the longer it takes to print) | ||
| - For Ultimaker: | - For Ultimaker: | ||
| Line 154: | Line 154: | ||
| ----- | ----- | ||
| + | |||
| + | [[ruler]] | ||
ultimaker_3_sop.1598545821.txt.gz · Last modified: 2020/08/27 16:30 by furst