wen_drill_press
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
| wen_drill_press [2020/07/13 19:06] – created furst | wen_drill_press [2020/10/08 16:41] (current) – [Safety Concerns] furst | ||
|---|---|---|---|
| Line 18: | Line 18: | ||
| ===== About ===== | ===== About ===== | ||
| + | This vertical drill press is one of the largest upright tools in the Innovations Workshop. It has a speed control lever on the left side of the head, and a vertical quill feed on the right. The chuck key is located on the right side of the head and should be replaced after use to avoid mixing chuck keys. | ||
| ---- | ---- | ||
| Line 24: | Line 24: | ||
| ===== Detailed Specifications ===== | ===== Detailed Specifications ===== | ||
| - | Table Size: | + | * Spindle Speed Range: 280-3,100 RPM (740-3,100 on main pulley) |
| + | * Quill extension length: 4 3/8" | ||
| + | * Max Drill Bit Diameter:16 mm | ||
| + | * Max Work piece Height: 44" | ||
| ---- | ---- | ||
| ===== Safety Concerns ===== | ===== Safety Concerns ===== | ||
| - | Insert Text Here! | + | * Safety glasses, close toe shoes, and long pants must be warn when operating the machine |
| + | * Metal chips can be incredibly sharp, do not touch any chips directly instead using an acid brush to remove chips | ||
| + | * Do not inhale any fumes resulting from drilling using oil | ||
| + | * Do NOT wear gloves during operation of machine | ||
| + | * Do not touch tool or spindle until the machine has stopped completely | ||
| ---- | ---- | ||
| Line 48: | Line 56: | ||
| ===== Training Documentation ===== | ===== Training Documentation ===== | ||
| - | {{: | ||
| + | |||
| + | [[Drill Press SOP]] | ||
| ---- | ---- | ||
wen_drill_press.1594667212.txt.gz · Last modified: 2020/07/13 19:06 by furst