NSF BioPACIFIC MIP Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== FormCure UV Curing Station ======

^                   FormCure UV Curing Station                          ^
|            {{ :tools:formcureuv:formcureuv.png?nolink&200 |}}         |                                                 
| **Tool Type:**                  "UV Curing Station"                           |
| **Location:**                   "Innovations Worship"                           |


|  **Supervisor**        |  **Tool Lead**  |     
|  David Bothman         |  "WW Name"  |
|  (805) 893-4125        |  (###) ###-####  |
|  bothman@cnsi.ucsb.edu  |  "WW Email"  |

| **Description:**                "FormLabs Curing Station"                           |
| **Manufacturer:**               "FormLabs"                           |

----

===== About =====

Some FormLabs Resins used in the Form 2 3D printer can benefit from post process curing. Each resin has a specific hardening curve which can be found within the reference material which will indicate the ideal time and temperature to be set on the FormCure.

----

===== Detailed Specifications =====
  * Max cure temp: 80 degrees C
  * Light: 39W total drawn by 13 405 nm LEDs


----

===== Safety Concerns =====

  * Allow at least half an hour for IPA to evaporate before placing part in Form Cure
  * Allow time for the Form Cure to cool off before removing parts
  * Do not operate form cure with lid open

----

===== Operating Procedures =====

  - Any part to be cured needs to be washed in the FormWash with IPA BEFORE being placed in the form cure. Supports can be removed before or after curing process.
  - Wait 30 minutes after washing to allow all remaining IPA to evaporate
  - Check the reference material for selected resin to determine ideal time and temperature for curing
  - Use the dial on the front of the FormCure to set time and temperature
  - Place part within the FormCure-> press start.

-----

===== Reference Documentation =====
[[https://support.formlabs.com/s/article/Using-Form-Cure?language=en_US]]

[[https://support.formlabs.com/s/article/Form-Cure-Time-and-Temperature-Settings?language=en_US]]

[[https://support.formlabs.com/s/article/Form-Cure-Time-and-Temperature-Settings?language=en_US]]





===== Training Documentation =====
[[form2sop|Form 2 Training SOP]]
----