Differences

This shows you the differences between two versions of the page.

--- mono3z2_dlp_3d_printer_visible_light [2024/10/10 17:14] – [Safety Concerns] mbates
+++ mono3z2_dlp_3d_printer_visible_light [2024/10/10 17:20] (current) – [Safety Concerns] mbates
@@ Line 29: / Line 29: @@
 ----
 ===== Manuals =====
-{{ ::gradient_mnwr-s01-job_file_structure.pdf |}}\\
+{{ ::gradient_mnwr-s01-job_file_structure.pdf |MonoWare Job File
-{{ :mn3z-c01a-mono3z2_assembly.pdf |}}\\
+Structure}}\\
-{{ :mn3z-c01c-mono3z4_assembly.pdf |}}\\
+{{ :mn3z-c01a-mono3z2_assembly.pdf | MONO3Z2 (2CH) Initial Assembly & Alignment}}\\
-{{ :mn3z-c02-mono3z_printer_firmware.pdf |}}\\
+{{ :mn3z-c01c-mono3z4_assembly.pdf | MONO3Z4 (4CH) Initial Assembly & Alignment}}\\
-{{ :mn3z-c04-mono3z_first_printing.pdf |}}\\
+{{ :mn3z-c02-mono3z_printer_firmware.pdf |MONO3Z Series Printer Firmware}}\\
-{{ :mn3z-c05-mono3z2_led_swapping.pdf |}}\\
+{{ :mn3z-c04-mono3z_first_printing.pdf | Mono3Z First Printing}}\\
-{{ :mn3z-c08-mono3z4_4ch_printing.pdf |}}\\
+{{ :mn3z-c05-mono3z2_led_swapping.pdf |MONO3Z2 LED Swapping}}\\
-{{ :mn3z-c12-mono3z2_wiper_heater.pdf |}}\\
+{{ :mn3z-c08-mono3z4_4ch_printing.pdf |MONO3Z4 (4CH) Printing File}}\\
+{{ :mn3z-c12-mono3z2_wiper_heater.pdf |MONO3Z2 (2CH) Wiper & Heater}}\\
 ----
@@ Line 43: / Line 44: @@
 Read the manufactures manual before first use. If the Mono3Z2 acts in a way that is not described by the manual, turn off the printer and contact the principal scientist as well as Mono at info@monoprinter.com .\\
-	* Never place your finger near the machine until all parts have stopped moving. Moving parts can cause serious injury\\
+	* Never place your finger near the machine until all parts have stopped moving. Moving parts can cause serious injury.\\
-	* Never clean or service the printer while it is on\\
+	* Never clean or service the printer while it is on.\\
-	* The printer uses different LEDS. Never look directly at LED light nor expose skin. Serious injury may result from exposure\\
+	* The printer uses different LEDS. Never look directly at LED light nor expose skin. Serious injury may result from exposure.\\
-	* Disassembling the printer may cause an electric shock or damage to the instrument.    Do not disassemble any parts of the printer not mentioned in the instruction manual.    In case of a problem with the printer\\
+	* Disassembling the printer may cause an electric shock or damage to the instrument.    Do not disassemble any parts of the printer not mentioned in the instruction manual.\\
 ----