This is an old revision of the document!
Table of Contents
UV Curing Oven
| AMP LED UV-Cube II |
|---|
 |
| Tool Type: “UV Oven” |
| Location: “Elings 2436” |
| Supervisor | Tool Lead |
| Juan Manule Uruena | “WW Name” |
| (###) ###-#### | |
| jmuruena@ucsb.edu | “WW Email” |
| Description: “UV curing oven” |
| Manufacturer: “AMP LED UV-Cube II” |
About
Some Carbon Resins used in the Carbon 3D printer can benefit from post process curing. Each resin has a specific hardening curve which can be found within the reference material which will indicate the ideal time and temperature to be set on the UV curing oven.
Training Documentation
Detailed Specifications
Build Volume: 189 x 118 x 326 mm (L x W x H)
X,Y Accuracy: 75 microns
Layer Thickness: 25-100 microns
General Accuracy: up to +/- 70 µm +1 µm per mm dimension size
Production Repeatability: up to +/- 40 µm
Safety Concerns
The resin used in the Carbon 3D printer is considered hazardous. Gloves are to be warn when replacing or removing build plates, build tanks, and resin cartridges. Refer to SDS for disposal and health hazards.
Operating Proceduces
1. Any part to be cured needs to be washed in the FormWash with IPA BEFORE being placed in the form cure.
2. Supports can be removed before or after curing process.
3. Wait 30 minutes after washing to allow all remaining IPA to evaporate
4. Check the reference material for selected resin to determine ideal time and temperature for curing
5. Use the dial on the front of the FormCure to set time and temperature
6. Place part within the FormCure→ press start.