The Ultimaker 3 extended is a filament fed fusion deposition 3D printer capable of simultaneously printing two different plastics at once. Typically the printer is set up with ABS as a build material, and PVA as a solvable support material.

FDM Printer SOP
Ultimaker 3 Quick Review

Build Volume: 215 x 215 x 300 mm
Filament diameter: 2.85 mm
layer resolution: 60 to 600 microns depending on print head (see Specifications documentation page 11)
XYZ accuracy: 12.5, 12.5, 2.5 microns
Build plate temperature: 20-100 °C
Nozzle temperature: 80 - 100 °C

Insert Text Here!

1. Launch Cura version 4 (blue icon)
2. From connected printers, select IW-Ultimaker3
3. Select File → Open Files → Open desired project (.STL file type)
4. Using task bar on the left hand side, position model as desired
5. From print settings, select slice height, infill percentage, and support
6. Support can be generated using ether nozzle, typically nozzle one holds build material with nozzle two printing with dissolvable support material.
7. Setting can be fined tuned using the “Custom” option from print settings
8. Within custom settings, nozzle and build plate temps can be adjusted (build plate temps should be based off of build material)
9. Save the file from Cura on a thumb drive
10. Connect thumb drive to printer → select desired file → select print
    

Note: Adjusting settings may lead to more (OR LESS) successful prints. Contact Workshop Wizard responsible for Ultimaker if print fails or knowledge of advanced settings is desired.

PVA Temps
Extruder: 220 C Bed: Whatever structural filament recommends

ABS Temps
Extruder: 230 C Bed: 100 C

quick_start_guide_ultimaker_3_v3.2.pdf
ultimaker_3_extended_specifications.pdf
um180129_ultimaker_3_manual_rb_v12_english.pdf
https://support.ultimaker.com/hc/en-us/articles/360012007119
pva_drying_recipe.pdf
ultimaker_filaments_-_sheet1.pdf

FDM Printer SOP
failed_3d_print_procedure.pdf